Silencers/Suppressors really don’t silence or suppress anything in airsoft, they’re mainly for looks, although they increase accuracy. This post will show you how to make a simple airsoft silencer/suppressor from around the house items. In order for this silencer/suppressor to work, you need to put it on a airsoft gun that has a long-ish safety tip that your silencer can fit over, like this:

This is what you need:

• A cardboard paper towel roll
• Foam pipe instillation (1/2 inch diameter is fits the average gun, but you can buy 3/4 inch and up, depending on how large your orange safety tip is. It’s better to end up with a loose fitting one than one that won’t fit at all)
• Tape (duct tape is best)
• Bright orange tape (again, orange duct tape is best)
• Spray paint (it’s up to you what color you want your silencer; black is standard, but you can make it match the color of your gun, or you can use a fun color, or OD Green looks pretty cool)
• Cutting tools (to cut your paper towel roll, the instillation, and the tape)

Step 1 – The first thing you do is take your paper towel roll and the pipe instillation and cut them both to a length of 8in. You can make them shorter for CQB, but just make sure they’re the same size (also, save any piece of cardboard paper towel roll that you cut off to use later):

Step 2 – Next, fit the pipe instillation into the cardboard roll; it should be a snug fit:

Step 3- Now tape both ends up with tape so the pipe instillation won’t come out. Tape one end with the normal duct tape and tape the other with the bright orange (just make sure that you don’t cover up the hole of the pipe instillation):

Step 4 – Now all that’s left is to spray paint the whole thing. Just do not paint over the orange duct tape; this with serve as a safety tip (it’s illegal to have a airsoft gun without a bright orange tip on the end of it):

Step 5 – Now simply slide your silencer/suppressor over the orange safety tip on your gun. If it’s loose then you can take the little piece of cardboard roll that you saved earlier and cut it so you can open it up. Then roll it as tight as you can and glue it to the inside of the silencer. What this will do is make a smaller hole for your tip to fit in. This is what it should look like when it’s on your gun:

Like I said, it doesn’t silence or suppress, but it will increase the accuracy and look really cool. If you have problems with the silencer falling off then you can take the extra piece of cardboard and make the suppressor hole smaller, as explained above. Or, if you know you want the silencer on your gun for a while, you could even glue or tape the silencer onto your gun, although the cardboard trick should keep the silencer in place.

Please give all credit for this project to SirBuffaloSushi and AirsofterUnited.wordpress.com