The BattleAxe Dual Magazine Connector is designed to fit almost any M4 or M16 airsoft magazine, making reloading times faster and helping to conserve space.
Each of the BattleAxe Connectors (each pack comes with two of them, as you can see in the picture above) is made up of 4 pieces: a large plastic buckle in the front, a smaller plastic piece in the back, a long screw that connects the two plastic pieces and also runs in between the two magazines, and finally the olive-drab strip of fabric that holds the magazines in place.
The whole connector is cheaply made, but in particular the olive-drab straps are very thin and the ends fray very easily. Right out of the package all four of the ends weren’t properly tied, and were starting to fray. A simple solution here is to, as soon as you get the connector, take a couple pieces of duct-tape and sandwich about 1 inch of the end of the strap between it. This will help keep it from fraying and make it a little more durable.
How the connector works is each of the magazines go in between the screw that runs down the middle and the olive-drab strap on either side. You then pull the strap tight and tighten the screw in the back to give it added stability. However, some M4 and M16 magazines might be too wide to fit in between the plastic piece in the front and the plastic piece in the back. In most cases you can just loosen the screw until the two plastic pieces are far enough away from each other for the magazine to fit in between. But, in other cases, you might need to purchase a longer screw.
The last issue worth noting is that the magazines do start to slide up/down after extended use, but this is something you just have to live with because all magazine connectors are going to have the same problem, more or less.
Through all the down-sides, the BattleAxe magazine connector isn’t all bad. The reloading time is just about the same with AEGs because you still have to wind up the magazine, you can’t just pop it in and start shooting. But, it works very well for spring guns that magazines you don’t have to wind up. And it’s also great for saving space, keeping the extra magazine on the gun itself instead of having to keep it on you body.
Although, BattleAxe says that their magazine connector is just as good as any metal magazine connector, which I can’t say is true because you don’t have fraying/durability problems with the metal connectors as much as you do with this fabric and plastic one.
In closing, the BattleAxe M4/M16 Dual Magazine Airsoft Connector isn’t all bad. It certainly has some quality issues, but it’s cheaper and lighter than the metal connectors. And as long as you don’t expect too much, the BattleAxe magazine connector might be all you need.
Also note that it does not come with the two magazines. Unless whoever you’re buying from specifically says otherwise, all you get are the two connectors; you need your own two magazines to use in partnership with the connectors.